How To Start A Stihl Weed Eater Fs 56 Rc?

How to Start a Stihl Weed Eater FS 56 RC

The Stihl FS 56 RC is a powerful and versatile weed eater that can be used for a variety of tasks, from clearing brush to trimming hedges. However, before you can use it, you need to know how to start it.

This guide will walk you through the process of starting your Stihl Weed Eater FS 56 RC. We’ll cover everything from basic safety precautions to the specific steps involved in starting the engine.

So whether you’re a first-time user or you’re just looking for a refresher, read on for all the information you need to know.

Step	Instructions	Image
1	Make sure the Weed Eater is turned off and the spark plug wire is disconnected.
2	Pull the primer bulb 5-6 times to prime the engine.
3	Place the Weed Eater on a level surface and squeeze the throttle trigger.
4	While squeezing the throttle trigger, pull the starter rope until the engine starts.

Pre-Starting Checklist

Before you start your Stihl Weed Eater FS 56 RC, it is important to perform a pre-starting checklist to ensure that the machine is in proper working order. This checklist will help you identify any potential problems that could prevent the engine from starting or running properly.

Check the fuel level. The fuel tank should be at least half full. If the fuel level is low, fill the tank with fresh fuel.

Check the oil level. The oil level should be between the “full” and “add” marks on the dipstick. If the oil level is low, add oil until it reaches the “full” mark.

Inspect the spark plug. The spark plug should be clean and free of deposits. If the spark plug is dirty, clean it with a spark plug cleaner or a wire brush.

Inspect the air filter. The air filter should be clean and free of debris. If the air filter is dirty, replace it with a new one.

Starting the Engine

Once you have completed the pre-starting checklist, you can start the engine of your Stihl Weed Eater FS 56 RC.

Turn the choke on. The choke is a valve that limits the amount of air that enters the carburetor. This helps to enrich the fuel mixture and make it easier to start the engine.

Pull the starter rope slowly until you feel resistance. This will prime the carburetor with fuel.

Pull the starter rope quickly until the engine starts. Once the engine starts, you can release the choke.

Troubleshooting

If your Stihl Weed Eater FS 56 RC is not starting, there are a few things you can check to troubleshoot the problem.

Check the fuel. Make sure that the fuel tank is full and that the fuel is fresh.

Check the spark plug. Remove the spark plug and inspect it for damage. If the spark plug is damaged, replace it with a new one.

Check the air filter. Remove the air filter and inspect it for debris. If the air filter is dirty, replace it with a new one.

Check the carburetor. The carburetor may be dirty or out of adjustment. If you are not comfortable working on the carburetor, take your Weed Eater to a qualified service center.

Starting your Stihl Weed Eater FS 56 RC should be a simple process. By following the steps in this guide, you can ensure that your Weed Eater is in proper working order and that you can get started on your next project.

Here are some additional tips for starting your Weed Eater:

• Start the engine in a well-ventilated area.
• Wear safety glasses to protect your eyes from flying debris.
• Do not start the engine if the Weed Eater is not properly assembled.
• Do not start the engine if the Weed Eater is damaged.

By following these tips, you can safely and effectively start your Stihl Weed Eater FS 56 RC.

Adjusting the Carburetor

The carburetor on a Stihl Weed Eater FS 56 RC is responsible for mixing the fuel and air in the correct proportions for the engine to run properly. If the carburetor is not adjusted correctly, the engine may run too rich or too lean.

A rich mixture means that there is too much fuel in the air-fuel mixture, while a lean mixture means that there is too little fuel in the air-fuel mixture. A rich mixture can cause the engine to backfire, smoke, and run rough. A lean mixture can cause the engine to lose power and stall.

To adjust the carburetor on a Stihl Weed Eater FS 56 RC, you will need the following tools:

• A flat-head screwdriver
• A Phillips head screwdriver
• A carburetor adjustment tool

1. Turn off the engine and allow it to cool down.
2. Remove the air filter cover.
3. Locate the carburetor adjustment screws. There are two screws: a low-speed mixture screw and a high-speed mixture screw.
4. Use the flat-head screwdriver to turn the low-speed mixture screw clockwise or counterclockwise until the engine runs smoothly at idle.
5. Use the Phillips head screwdriver to turn the high-speed mixture screw clockwise or counterclockwise until the engine reaches its maximum speed.
6. Reinstall the air filter cover.

If the engine is still running too rich or too lean after adjusting the carburetor, you may need to take it to a qualified service technician.

Troubleshooting

If the engine won’t start, check the following:

• Is there fuel in the tank? Make sure that the fuel tank is full and that the fuel valve is open.
• Is the spark plug properly gapped? The spark plug should be gapped to 0.030 inches.
• Is the air filter clean? A dirty air filter can restrict airflow to the engine and cause it to stall.
• Is the carburetor adjusted correctly? The carburetor may need to be adjusted if the engine is running too rich or too lean.

If you have checked all of these things and the engine still won’t start, you may need to take it to a qualified service technician.

This guide has provided you with the information you need to start and maintain your Stihl Weed Eater FS 56 RC. By following these steps, you can ensure that your weed eater is running properly and that you are getting the most out of it.

How do I start a Stihl Weed Eater FS 56 RC?

1. Make sure the trimmer is turned off and the spark plug wire is disconnected.
2. Fill the fuel tank with fresh, unleaded gasoline.
3. Attach the trimmer line to the head.
4. Pull the starter rope slowly until you feel resistance, then pull it quickly.
5. If the trimmer does not start, repeat steps 4 and 5.

What should I do if the trimmer won’t start?

1. Check the spark plug wire to make sure it is connected properly.
2. Check the fuel tank to make sure it is full and that the fuel is fresh.
3. Clean the carburetor.
4. Replace the spark plug.

How do I adjust the trimmer line?

1. Turn off the trimmer and disconnect the spark plug wire.
2. Use the trimmer’s line adjuster to release the tension on the line.
3. Cut the line to the desired length.
4. Reattach the spark plug wire and turn on the trimmer.

How do I maintain my Stihl Weed Eater FS 56 RC?

1. Clean the trimmer after each use.
2. Replace the air filter every 25 hours of use.
3. Replace the spark plug every 100 hours of use.
4. Service the carburetor every 200 hours of use.

Where can I get replacement parts for my Stihl Weed Eater FS 56 RC?

You can get replacement parts for your Stihl Weed Eater FS 56 RC at your local Stihl dealer or online at www.stihl.com.

starting a Stihl Weed Eater FS 56 RC is a simple process that can be completed in just a few steps. By following the steps outlined in this guide, you can be sure that your weed eater will be up and running in no time.

Here are the key takeaways from this guide:

• Make sure that the spark plug cap is securely tightened.
• Turn the choke on and press the primer bulb several times.
• Pull the starter rope until the engine starts.
• Allow the engine to warm up for a few seconds before using it.

By following these steps, you can safely and easily start your Stihl Weed Eater FS 56 RC.